Plug the trash compactor back in and reinstall the compactor in the cabinet.
Trash compactor door jammed.
However if you compactor will not open there are a couple of things to check first.
The drive chain on the ram drive system might have broken become jammed in the gears or fell off the gears completely.
Step 1 return ram to the top position.
Is the ram all the way up.
The steps are given in order of ease to try out the solution as it is usually hard to know the exact problem with the compactor s door with a door that won t open.
If you can t manually lift the ram and the container is full of trash carefully tilt the trash compactor forward and remove the bottom panel.
The power nuts raise and lower the ram and if they become stripped over time the ram may start making a banging noise.
Left and right arrows move across top level links and expand close menus in sub levels.
Trash compactors will normally open when the foot pedal is engaged.
Avoid spilling liquids if possible.
A condition where the ram was not capable of pushing the trash out and into the trash bag.
Use a helper to steady the trash compactor while removing the bottom panel.
Trash compactor door latch.
If you need to repair a trash compactor here are a few steps that you will find useful.
If your trash compactor is jammed or stuck with the ram in the down position the problem may be with the drive gear.
If your trash compactor is jammed there may be a defective power nut causing the ram to be stuck in the down position.
Because the compactor was overly full beyond intended use and the ram was unable to handle the pile up the porter used a stick to assist the ram in.
Power nuts also known as trunnion nuts are driven by power screws and attached to the sides of the ram.
The porter testified that the morning s accumulation of trash resulted in a jammed condition i e.
The site navigation utilizes arrow enter escape and space bar key commands.
Trash compactor product assistance expand collapse global location trash compactor drawer won t open.
The drive motor has a small gear attached to the shaft and this gear meshes with the larger drive gear which in turn operates the chain that powers the ram screws.
