Flare x 7 8 in.
Toilet water supply line rough in.
Install a inch copper water line to the location of your new toilet.
Measured from centerline running vertically through the center of the toilet supply line hole should be 6 inches to the side of centerline.
From the center of the water closet flange measure 6 to the left then come up 7 above the finished floor.
Check toilet to confirm location water supply connection.
And as long as you have 21 or 24 of clearance when the door is shut you re good to go literally.
The default spacing is measured outward from the flange and from the finished floor up to the wall.
Find toilet faucet supply lines at lowe s today.
Determine the dimensions and location of your new toilet first.
This process is usually done when setting up a new bathroom.
Part of learning how to rough in plumbing is roughing in a toilet which is easier since the p trap is already built into the toilet.
Braided polymer toilet connector.
Insert the line through the bottom plate on the wall approximately 8 inches to the left of the toilet s center line.
Mark this spot and use a ruler.
The general guide is six inches from the center to the left as you look at it facing the back wall.
Ideally 8 1 4 inches above the floor.
Connect this supply line at the water line attached to the sink.
The final rough in is for the toilet called water supply line.
To install the water supply line take your line and run it from the designated water supply directly up through the floor or inside the wall so that it comes out near the side of the toilet tank that has the water supply link fixture.
Model nl 27412 4 99 piece 4 99 piece free delivery with 45 order.
Check your local building codes for clearance requirements.
Set your store to see local availability add to cart.
Where to put the cold water supply line.
How to rough in a toilet.
Cold water only pipe creates one hole between 5 and 10 inches above the floor supply line horizontal.
Rough in bathroom plumbing involves preparing the pipes and drain lines for connection once a bathroom fixture is put in place.
The plumber s choice toilet connector water line 3 8 in.
Step 4 install the supply line.
Female compression balcock nut toilet supply line 12 in.
You will also have only one water supply line to connect.
Use a 90 degree elbow or stub out fitting to insert the water line into the surface plane.
Rough in for the water supply line.
The final measurement is 4.
Toilet rough in details.
