Nominal door width 1 1 4 height.
Timely pocket door frame rough opening.
The purpose of the p series is to make pocket door openings consistent with other timely frames on.
In some cases wood pocket frames are used that include a 3 4 strike jamb piece the full width of the wall.
Nominal height 1 net height 13 16 net height.
Maximum space for adequate anchorage is 1 3 16 over net height resulting in approximately 5 16 of the frame face against the wall.
Of frame is 40 x 86 as the frame face is 2 around all 3 sides.
Corporate office 818 492 3500 or.
In some cases wood pocket frames are used that include a 3 4 strike jamb piece the full width of the wall.
Make the rough opening for a pocket door two times the width of the door plus 1 inch with a height of 84 1 2 inches from the highest spot on the subflooring.
The rough opening for pocket doors is actually created by the pocket frame system used.
Rough opening height must provide clearance to level the header and interlock the jambs.
Timely industries is the leading manufacturer of prefinished steel door frames outperforming other door frames with lower opening costs.
Backboard of frame inserts flush with end of header fasten with nails or screws not provided.
Pocket trim kit p series 18 gauge shown with ta 8 steel casing as example.
Yes specify inverted stop on the strike jamb.
The timely p series trim kit is designed to fit most common applications.
Can timely provide a pocket trim set with a door recess on the latch side.
While this opening looks very large it must accommodate the door once it slides in the pocket to open.
Uneven floors will affect this measurement.
Corporate office 818 492 3500 or 800 247 6242 fax 818 492 3530.
De series frames are commonly used for openings requiring doors swinging in opposite directions.
The rough opening would be 40 1 2 x 86 1 4 for a 3 0 x 7 0 door frame.
Use shims and or caulk to seal gaps between wall and frame.
Stand complete frame into opening plumb and anchor to sub floor.
The header is 1 less than the door size instead of 1 2 as on a regular pocket trim jamb.
P series trim kits are used to trim out pocket door openings.
While this is not recommended the frame can still be installed.
The timely p series trim kit is designed to fit most common applications.
